Features K 0609 low viscosity general purpose cylindrical parts holding glue is a one component high strength general purpose low viscosity anaerobic cylindrical hole shaft fitting retaining adhesive The holding glue cures when it is isolated from the air between two closely fitting metals Typical use It is used for the hole shaft fittings with radial clearance 0 1mm to improve the press fit strength and prevent rust Used for transitions interference or clearance fits to repair worn holes shaft fittings or out of tolerance parts Typical applications assembly of new parts bearings bushings small motor rotor shafts bushings etc Specification Chemical composition methacrylateAppearance green viscous liquidViscosity 25 °C mPa s 100 300Specific gravity 1 05 1 10Maximum filling radial clearance mm 0 13Shear strength MPa ≥10Working temperature °C 54 149Initial curing time minutes ≤15Full solid hours 24Instructions for use The surface to be coated should be clean dry and free of grease For the sliding fittings it is only necessary to apply a circle of glue around the shaft and the guide angle of the sleeve and rotate it to the left and right during assembly to ensure good coating For press fit both quilt bonded surfaces are coated with glue and assembled on a suitable high pressure press For heat shrink fittings the glue should be applied to the shaft and then heated to produce sufficient clearance for free assembly Do not tamper with th
Price history
Apr 18, 2022
€10.57