Introduction 1 There are many ways to drive the motor Our robot uses the most commonly used L298P solution 2 L298P is an excellent high power motor driver IC produced by STMicroelectronics It can directly drive DC motors two phase and four phase stepping motors The driving current up to 2A and output terminal of motor adopts eight high speed Schottky diodes as protection 3 We have designed the motor driver shield based on the L298P circuit 4 The stackable design can make it be plugged directly into the ARDUIN0 reducing the technical difficulty of using and driving the motor 5 Direct stack the motor driver shield onto UNOR3 board after the BAT is powered on turn the Slide button ON to supply the power for both keyestudio motor driver shield V2 and UNOR3 board For simple wiring the motor driver shield comes with anti reverse PH2 0 2P connectors When connecting the motors just plug in directly 6 The Bluetooth interface on the motor driver shield is fully compatible with keyestudio HM 10 Bluetooth module When connecting just plug HM 10 Bluetooth module into the corresponding interface 7 At the same time the motor drive shield has brought out extra digital and analog ports in 2 54mm pin female headers so that you can continue to add other sensors for experiments extension 8 The motor drive shield can access to 4 DC motors And the 8 jumpers can be applied to control the turning direction of 4 motors For instance if change the 2 jumpers near the motor A co
Price history
Apr 18, 2022
€18.28